GRC外墻裝修構件成模性好，加工便利，能按規劃要求做成各種多面形狀異形的制品，所以用途比較廣泛。那么作為施工方來說，常用來固定grc裝修構件的辦法主要有哪些呢?
GRC exterior wall decoration components have good molding ability and convenient processing, and can be made into various products with various shapes and special shapes according to the planning requirements, so they are widely used. So as a construction party, what are the main methods to fix GRC decoration components?
grc裝修構件打孔，脹大螺栓裝置孔洞：深度依據GRC構件分量確認運用脹大螺栓型號，依據脹大螺栓型號挑選適宜鉆頭，孔洞避開鋼筋一次性成孔，孔洞的位置應依據GRC構件上預埋件位置確認。脹大螺栓裝置，先將脹大管放進孔洞，用錘子適度敲擊，裝置螺母。
Drilling of GRC decoration components and holes of expanding bolt device: confirm the use of expanding bolt model according to the GRC component depth, select the appropriate drill according to the expanding bolt model, avoid the reinforcement to form holes at one time, and confirm the location of holes according to the location of embedded parts on GRC components. For the expansion bolt device, first put the expansion pipe into the hole, hit it moderately with a hammer, and install the nut.
脹大螺絲錨固法：將GRC板按裝置要求在產品上預留螺孔——退拔狀，螺孔距離水平向大于400mm，垂直方向不大于500mm，然后用脹大螺絲直接錨固在墻面上。
Expansion screw anchoring method: Reserve screw holes on the GRC Plate according to the requirements of the device - pull back shape. The distance between screw holes is more than 400mm in the horizontal direction and not more than 500mm in the vertical direction, and then directly anchor the GRC Plate on the wall with expansion screws.
焊接法：在墻面上按GRC構件裝置要求設置預埋鐵件，然后用電焊焊。直接或用連桿把預埋在GRC內壁的鋼板焊接。為了確保裝置質量，在GRC構件裝置之前，要對墻基體表面的附著物進行相應的清理。預埋件要求在外墻表面以內15 mm，防止銹水外溢。
Welding method: set embedded iron parts on the wall according to the requirements of GRC component device, and then use electric welding. Weld the steel plate embedded in the inner wall of GRC directly or with connecting rod. In order to ensure the quality of the device, before the GRC component device, the attachments on the wall base surface shall be cleaned accordingly. The embedded parts are required to be within 15 mm of the outer wall surface to prevent the rust water from overflowing.
